Mighty Mite Neck for Strat Guitar, Compound radius, Indian Rosewood fingerboard

Description

Shaped, inlaid, fretted and finished—feels and plays great
Hard rock maple finished in clear satin polyurethane
Each neck has a single-action truss rod and traditional "skunk stripe" down the back
Peghead is drilled for 6-in-line tuning machines, with 10mm-diameter holes that fit sealed gear tuners with threaded peghead bushing
Features 25-1/2" scale length and compound radius fretboard (see Product Description for more specs)
Shaped, inlaid, fretted and finished—feels and plays great!
Hard rock maple finished in clear satin polyurethane, with an inlaid "skunk stripe" down the back.
Other features include:
The frets are nicely finished.
The string nut is slotted and shaped from PPS plastic with a flat bottom.
Indian Rosewood fretboard with dot inlays and side markers.
Screwholes for attaching to the body are not drilled.
Has a single-action truss rod with a 4mm adjusting nut at the peghead.
Peghead is drilled for 6-in-line tuning machines. 10mm-diameter holes fit sealed gear tuners with threaded peghead bushings.
Specifications:
Scale length: 25-1/2" (647.70mm)
Width at nut: 1-11/16" (42.86mm)
Width at 22nd fret: 2-3/16" (55.56mm)
Fretwire: .045" high x .095" wide (1.14mm x 2.41mm)
Fretboard radius: compound, 9-1/2" - 12"
Fret count: 22
String post spread: 4-11/16" (119.06mm)
Approximate heel length: 3-5/8" (92.07mm)
Fits neck pockets measuring 2-3/16" (55.56mm) wide x 3" (76.20mm) long x 5/8" (15.88mm) deep.
About the compound radius fingerboard —
The fingerboard surface radius gradually changes from 9.5" at the nut, to 12" at the 22nd fret (241mm to 305mm), for lower action and cleaner string bending. 14.75" (375mm) bridge saddle radius is recommended.
Neck thickness (approximate; not including fret):
.860" (21.84mm) at the 1st fret
.880" (22.35mm) at the 6th fret
.890" (22.61mm) at the 12th fret
Ideally, the neck should just drop into the neck-pocket, or be a little snug. Don't force the neck into the pocket. If the body is unfinished, remember that the finish will make the neck pocket smaller with lacquer build up on the edge of the rout. Be sure to compensate for the finish buildup or the neck will be too tight after finishing.